![]() The last step is to mount the motor on a lego plate such that you can actually use it in a lego project. You can modify this a little bit later, when the motor is finished. Slip gear D such that the axle comes out as you would like. Then insert the lego axle with gear D in it, and the result should look like the picture. Then put gear C on the iron axle with gear B in between. Mount the gears in the correct order:įirst A. Now, put gear D on the lego axle of your choice (I chose a length of 8). Gear D must be fixed tightly on the lego axle, so drill it with a smaller drill, around 4.5mm will do. You'll have to enlarge the hole in one side of the yellow enclosure as well with the 4.8mm drill (the half which is in the top of the picture). Do not let the gear slip if you hold it in a vice: the teeth will be damaged. You have to hold the gear while drilling: make sure you don't damage the teeth. Make it rotate smoothly over your lego axle. The smaller gear of gear B has notches, try to keep these as small as possible. Gear B must run smoothly over the lego axis, drill it with a 4.8 mm drill. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |